Skip to content
ConfigProof

All controls

FTD-SEC-007MediumCisco FTD

Rule does not log

At a glance

Base severity

Medium

Area

Security Policies

Platform

Cisco FTD

Evidence level

Fact1.00

Benchmark reference

Reads the export, not the device

ConfigProof reads a configuration export. This control is evaluated against the objects in that file, and it reports what the file says. It does not connect to the device and sees no traffic, so a finding here describes the configuration, not what the firewall is doing right now.

Why it matters

An allow or trust rule without end-of-connection logging, or a block rule without beginning-of-connection logging, leaves no audit trail for what it decided.

How to fix it

Web interface

The steps below are written for the web interface. A finding raised on your own export carries the same steps with your object names filled in.

  1. In FMC (or cdFMC): Policies > Access Control > edit the policy > edit the rule > Logging tab > Log at End of Connection (Allow, Trust) or Beginning (Block) > Event Viewer and/or Syslog Server. Save, Deploy.
  2. In FDM: Policies > Access Control > edit the rule > Logging tab > At End of Connection, then Deploy.

Command line

This analyzer version writes no command text for this control. The steps above are the remediation it offers.

How to confirm the fix

  • On the FTD CLI (read only): show access-control-config, and confirm the rule's Logging Configuration is enabled.

Limits

  • No limitation is recorded for this control beyond the one that applies to all of them: it reads a configuration export.

Compliance references

No benchmark recommendation is mapped to this control in this version.

More in Security Policies

See it on your own firewall

One complete analysis of one firewall costs nothing. A card is required and nothing is charged.

Start a free analysis