Disabled policy left in the table
At a glance
Base severity
Area
Platform
Evidence level
Benchmark reference
Reads the export, not the device
ConfigProof reads a configuration export. This control is evaluated against the objects in that file, and it reports what the file says. It does not connect to the device and sees no traffic, so a finding here describes the configuration, not what the firewall is doing right now.
Why it matters
A disabled policy stays in the table and does nothing. Enabled again by mistake, it applies again as written, which can restore access that was meant to be gone.
How to fix it
Web interface
The steps below are written for the web interface. A finding raised on your own export carries the same steps with your object names filled in.
- Confirm the policy is no longer needed, record why, and delete it.
Command line
FortiOS CLI
config firewall policydelete <policy-id>end
An example. Values in angle brackets are yours to supply; a finding on your own export fills in the names it read. FortiOS saves a change when you type next or end, with no separate commit. Read every line first.
Read it back
show firewall policy <policy-id>Values to fill in1
- <policy-id>
- The policy id to change
Before you type it3
- Written from the FortiOS CLI Reference, not yet run on a device. Read each line before typing it.
- On a device with VDOMs, type these inside the VDOM (config vdom, edit the VDOM) or inside config global for a global setting.
- A configuration shows definitions and references, not traffic, so review this before you run it.
How to confirm the fix
- Check that no change request still expects the policy.
Limits
- No limitation is recorded for this control beyond the one that applies to all of them: it reads a configuration export.
Compliance references
No benchmark recommendation is mapped to this control in this version.
More in Security Policies
- FGT-SEC-001Accept policy from every address to every address
- FGT-SEC-002Accept policy on service ALL
- FGT-SEC-003Accept policy does not log its traffic
- FGT-SEC-008Policy covered by an earlier policy
- FMG-MGT-004Managed FortiGate with no policy package installed
- FMG-MGT-005Policy package installed on no FortiGate
See it on your own firewall
One complete analysis of one firewall costs nothing. A card is required and nothing is charged.