Skip to content

All controls

CKP-MGT-018LowCheck PointCIS 2.5.2

Gaia Portal session times out after more than 10 minutes

At a glance

Base severity

Low

Area

Administrators and Access

Platform

Check Point

Evidence level

Fact1.00

Benchmark reference

CIS 2.5.2

Reads the export, not the device

ConfigProof reads a configuration export. This control is evaluated against the objects in that file, and it reports what the file says. It does not connect to the device and sees no traffic, so a finding here describes the configuration, not what the firewall is doing right now.

Why it matters

An unattended browser session stays logged in to the box's administration.

How to fix it

Web interface

The steps below are written for the web interface. A finding raised on your own export carries the same steps with your object names filled in.

  1. In the Gaia Portal, open System Management > Session and set the web session timeout to 10 minutes or less.
  2. Run save config in clish, or the change is lost at the next reboot.

Command line

Check Point mgmt_cli and Gaia clish

set web session-timeout 10save config

An example. Values in angle brackets are yours to supply; a finding on your own export fills in the names it read. Nothing here installs a policy. Publish, review, then install the policy on your gateways yourself; Gaia changes need save config.

Read it back

show web session-timeout
Before you type it2
  • Written from the Check Point Management API reference and Gaia clish syntax, not yet run on a device. Read each line before typing it.
  • Type in clish on each Gaia gateway or cluster member.

How to confirm the fix

  • Confirm an idle Gaia Portal session closes after the timeout.

Limits

  • No limitation is recorded for this control beyond the one that applies to all of them: it reads a configuration export.

Compliance references

2.5.2

CIS Check Point Firewall Benchmark v1.1.0

Covers the whole recommendation

Where a control aligns with a recommendation of the CIS Check Point Firewall Benchmark v1.1.0, that recommendation is cited as a reference. Only that version was checked. A reference is not a certification.

See it on your own firewall

One complete analysis of one firewall costs nothing. A card is required and nothing is charged.

Start a free analysis